Dual Port T1/E1/J1 PCIe w/EC HW

Producător: Sangoma
Cod produs: SANA102DEKIT
Disponibilitate: Stoc Furnizor
Preţ: 7.590,30 RON
Fără TVA: 6.378,40 RON
Descriere:Technical Specifications

Two T1/E1 spans with a single PCI or PCI-Express interface optimized for high performance voice and data applications
Mix T1 channel banks and E1 networks with full channel synchronization. TDM clocking mode lets network timing to be passed from a network-connected DS0 to any or all of the other spans, so both T1 and E1 are supported simultaneously
Support for Asterisk®, FreeSWITCH®, and Yate® as well as other Open Source and proprietary PBX, Switch, IVR, and VoIP gateway applications
All of Sangoma’s AFT products use the same base PCI interface card. Fully compatible with all commercially available motherboards—proper PCI-standard interrupt sharing without manual tuning.
Dimensions: 2U Form factor: 120 mm x 55 mm for use in restricted chassis. Includes high-quality, tested RJ45 cables and short 2U mounting clips for installation in 2U rack-mount servers
Intelligent hardware: Downloadable FPGA programming with multiple operating modes. Add new features related to voice and/or data when they become available
Autosense compatibility with 5 V and 3.3 V PCI busses
Line decoding: HDB3, AMI, B8ZS
Framing: CRC-4, Non CRC4, ESF, SF, D4T1/E1. Also compatible with Japan’s J1.
A102E and A102DE PCI Express: 1 Lane PCI Express bus
Maximum operational power for PCI: 3.8 W (0.76 A @ 5 V) For PCI Express: 3.2 W (0.97 A @ 3.3 V)
Temperature range: 0 – 50 °C
32-bit bus master DMA data exchanges across PCI interface at 132 Mbytes/sec for minimum host processor intervention
Ring buffer DMA handling for minimum host intervention and guaranteed data integrity on high volume systems
Supports Robbed Bit Channel Associated Signaling (CAS) and ISDN PRI
T1/E1 and fractional T1/E1, multiple channel HDLC per line for mixed data/TDM voice applications
Optimized per channel DMA streams and hardware-level HDLC handling unload the host CPU
Uses raw bitstream interfaces to support arbitrary non-standard line protocols, such as non-byte aligned monosynch or bisynch
WANPIPE® routing stack is completely independent of TDM voice application for total system reliability
WANPIPE® supports certified, field-tested, and reliable Frame Relay, PPP, HDLC, and X.25
Impedance: Configurable to 75ohms or 120ohms
Optional DSP Hardware Echo Canceller Daughtercard

G.168–2002 echo cancellation in hardware
1024 taps/128 ms tail per channel on all channel densities
DTMF decoding and tone recognition
Voice quality enhancement: music protection, acoustic echo control, and adaptive noise reduction
Does not increase the physical size of the card, and no additional slot is required
Operating Systems

Windows® 2003, Windows® XP, Windows® Server 2008, Windows® Vista, Windows® 7
Linux (all versions, releases and distributions from 1.0 up)
T1/E1 Status Alarms

RED: Telco Red Alarm Condition
OOF: Out of Frame
LOS: Receive Loss of Signal
AIS: Alarm Indication Signal
RAI: Remote Alarm Indication (Yellow Alarm)
Line Protocols

Voice CAS, MFC/R2, PRI, ATM, Frame Relay, X.25, HDLC, PPP, SS7, Transparent bit-stream, BSC

Higher Level Protocols

IP/IPX over Frame Relay/PPP/HDLC/X.25, X.25 over Frame Relay (Annex G), BSC over X.25, SNA over X.25, PPPoE,PPPoA, IP over ATM


FCC Part 15 Class A, FCC Part 68, CISPR 22, EN 55022, Class A, CIPSR 24, AFIC-2016, IEC 60950
Technical certifications in Russia, Malaysia and Australia atick
Diagnostic Tools



Lifetime warranty on parts and labour. Plus a 30-day no questions asked return policy.

Production Quality

ISO 9002

RJ45 T1/E1 Pinouts

Garantie :12 Luni