Tripp Lite SMX1500SLT - 1.5kVA 8 C13 outlets Smart Pro Inteligent Line Interactive UPS / USB, RS-232

Producător: Tripp Lite
Cod produs: TLSMX1500SLT
Disponibilitate: Stoc Furnizor
Preţ: 2.027,57 RON
Fără TVA: 1.703,84 RON
Descriere:SmartPro 230V 1.5kVA 900W Line-Interactive Sine Wave UPS, SNMP, Webcard, Tower, USB, Serial
Model Number: SMX1500SLT

OUTPUT
Output Volt Amp Capacity (VA) 1500
Output kVA Capacity (kVA) 1.5
Output Watt Capacity (Watts) 900
Power Factor 0.6
Nominal Output Voltage(s) Supported 220V; 230V; 240V
Nominal Voltage Details 230V default (voltage selection via back panel switches)
Frequency Compatibility 50 / 60 Hz
Output Voltage Regulation (Line Mode) -9% / + 5%
Output Voltage Regulation (Battery Mode) +/- 5%
Output Receptacles (8) C13
Included Output Power Cables Includes 2 C13 to C14 output power cables
Hot-Swap PDU options PDUBHV10 (2U / 8 C13 outlets)
Output AC Waveform (AC Mode) Sine wave
Output AC Waveform (Battery Mode) Pure Sine wave
INPUT
Rated input current (Maximum Load) 4.1A (220V),3.9A (230V), 3.8 (240V)
Nominal Input Voltage(s) Supported 220V AC; 230V AC; 240V AC
UPS Input Connection Type C14 inlet
UPS Input Connection Description IEC320-C14 input connection accepts a variety of detachable cordsets to match country or site-specific wall receptacles
Input Phase Single-Phase
BATTERY
Full Load Runtime (min.) 8 min. (900w)
Half Load Runtime (min.) 20 min. (450w)
DC System Voltage (VDC) 36
Battery Recharge Rate (Included Batteries) Less than 8 hours from 10% to 90% (typical, full load discharge)
Internal UPS Replacement Battery Cartridge RBC36-SLT
Battery Access Battery access door
Battery Replacement Description Hot-swappable, user replaceable batteries
VOLTAGE REGULATION
Voltage Regulation Description Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 182 to 278 (230v), 190 to 290 (240v), 174 to 266 (220v)
Overvoltage Correction Voltage reduction of 12% applies when input is 244 to 278 (230v), 254 to 290 (240v), 232 to 266 (220v)
Undervoltage Correction Voltage boost of 14% applies when input is 182 to 206 (230v), 190 to 216 (240v), 174 to 198 (220)
USER INTERFACE, ALERTS & CONTROLS
Switches 2 Switches control off/on power status and alarm-cancel/self-test operation; rear panel protected switches support nominal voltage selection
Alarm Cancel Operation Power-fail alarm can be silenced using alarm-cancel switch
Audible Alarm Audible alarm indicates power failure and overload conditions
LED Indicators 9 LEDs indicate line power, battery power, AVR, overload and replace battery status - with a 3-LED level meter for load and battery charge level
SURGE / NOISE SUPPRESSION
UPS AC Suppression Joule Rating 350
UPS AC Suppression Response Time Instantaneous
UPS Dataline Suppression 1 line TEL/DSL (1 in / 1 out); 10/100Base T Ethernet
EMI / RFI AC Noise Suppression Yes
PHYSICAL
Primary Form Factor Tower
UPS Power Module Dimensions (hwd, in.) 10.2 x 6.8 x 13.2
UPS Power Module Dimensions (hwd, cm) 26 x 17.1 x 33.7
UPS Power Module Weight (lbs.) 45
UPS Power Module Weight (kg) 20.4
UPS Shipping Dimensions (hwd / in.) 14 x 9.8 x 18.5
UPS Shipping Dimensions (hwd / cm) 35.6 x 24.8 x 47
Shipping Weight (lbs.) 48.6
Shipping Weight (kg) 22.1
Cooling Method Fan
UPS Housing Material Steel
ENVIRONMENTAL
Operating Temperature Range +32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius
Storage Temperature Range +5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius
Relative Humidity 0 to 95%, non-condensing
AC Mode BTU / Hr. (Full Load) 195.3
Battery Mode BTU / Hr. (Full Load) 582.9
AC Mode Efficiency Rating (100% Load) 94%
Audible Noise Audible Noise < 50 dBA at Front Side 1 Meter
COMMUNICATIONS
Communications Interface USB; DB9 Serial; Slot for SNMP/Web interface
Network Monitoring Port Description Supports detailed monitoring of UPS and site power conditions
PowerAlert Software Included
Communications Cable USB and DB9 cabling included
WatchDog Compatibility Supports Watchdog application, OS and hard-reboot restart options for remote applications
LINE / BATTERY TRANSFER
Transfer Time 4-8 milliseconds
Low Voltage Transfer to Battery Power (Setpoint) 174V (220V), 182V (230V) or 190V (240V)
Hi
Garantie :24 Luni